GM2stand

This stand/scoop holder is a 3D printed unit done in house from ASA filament which is more UV and heat resistant than other filaments.

The scoop holder fits the standard range of scoops we sell which are approximately 27 mm in handle size, and are universally used by many people. Simply place it in front of your control box assembly and tighten the wing nut to hold it firm. The scoop fits into the round holder on the stand to keep it close at hand.

Note; We have redesigned these to remove the slot and strengthen the V section. The stand is also slightly different in shape to allow for a much better print quality and finish.

Dimensions

Approximately

Ground to shaft bottom - 67 mm

Legs centre to centre - 150 mm

Width - 36 mm

Weight - 110 grams approximately

Compatible detectors

Gold Monster 1000

Gold Monster 2000

Equinox range

X-Terra Pro etc.