Products

RSS Small River Sluice The Oz Wash Brand River sluices are manufactured in Australia to suit our rugged conditions.This Small sluice was designed t...

3011-0027 Standard Minelab lower shaft washers. Suit - SD/GP/GPX shafts. This is a genuine Minelab spare part.

3011-0163 Treasure bag This pouch is approximately 240 mm wide and 300 mm high. it has a zippered section for valuables, a velcro section for other...

SBG 4.0 Sample bottle Glass with four ounce capacity and screw on lid.

SBG 1/2 Sample bottle Glass with one ounce capacity and screw on lid.

SBG 1.0 Sample bottle Glass one ounce capacity and screw on lid.

SBG 2.0 Sample bottle Glass with two ounce capacity and screw on lid.

SBP 1/2 Sample bottle Plastic with half ounce capacity and screw on lid.

SBP 1.0 Sample bottle Plastic with one ounce capacity and screw on lid.

BSS This plastic sand scoop is designed for digging targets in soft sand on the beach and then shaking it to get rid of the sand while leaving behi...

1600970 Metal sand scoop by Garrett. Perfect for beach detecting with the durability of steel for longer lasting usage. Dimensions Approximately 17...

1600971 Plastic sand scoop by Garrett. Perfect for beach detecting with the ability to pass the detector over the scoop or vice versa to check if t...

1600900 Stainless steel sand scoop by Garrett. Perfect for beach detecting with the durability of stainless steel for longest lasting usage and rus...

SCP Hard plastic scoop (polycarbonate) to help with recovery of those tiny nuggets from the spoil heap. Especially useful for SDC2300 and GPZ700 wh...

SHVAR22 This scoop holder clips onto a 22 mm shaft and is designed to house the standard range of scoops we keep that are approximately 27 mm in sh...

SHGPX6 This scoop holder clips onto a 20 mm shaft like the GPX6000 centre shaft, and is designed to house the standard range of scoops we keep that...

SHGPZ7 This scoop holder clips onto a  GPZ7000 centre shaft and is designed to house the standard range of scoops we keep that are approximately 27...

SHGPZ8 This scoop holder clips onto a  GPZ8000 upper shaft and is designed to house the standard range of scoops we keep that are approximately 27 ...

3011-0403 SDC2300 knuckle guard Minelab have produced a coil knuckle protector to prevent wear from the area that the coil swivels at. These are a ...

3011-0282Replacement intermediate (centre) carbon fibre shaft to suit the GPZ7000 metal detector.This is a genuine Minelab spare part.

3011-0130Replacement carbon fibre lower shaft to suit the CTX3030 metal detector. Good to fit to an extra coil for quick changes or as a spare.This...

3011-0401Replacement lower shaft to suit the EQUINOX series metal detectors. Does NOT include lower rubbers.This is a genuine Minelab spare part.

3011-0291 Replacement lower shaft to suit the GPZ7000 metal detector. Includes the rubber washers and bolts. This is a genuine Minelab spare part.